This lab seeks to illustrate the fundamental operation of uncontrolled rectifier circuits. The waveforms associated with these circuits are visualized using simulation and experimentation. The circuit ...
Frequency mixers are often implemented using a diode bridge or a Gilbert cell. Both types of mixers use a local oscillator (LO) to flip the polarity of the radio-frequency (RF) input. When the LO is ...
Range finders are used for a wide range of tasks, from measuring the distance to an object a few feet away to the distance between the moon and the earth. They work by sending a group of energy pulses ...
It is possible to operate Sheaumann’s diode laser pumped 2.94 µm Er:YAG MIR-Pac laser product 1,2 in the quasi-continuous-wave (QCW) pulsed mode of operation. This mode is often referred to as ...
The digital output high is set by the LT1716 supply voltage, 5 V as shown. 3. Waveforms for circuit of Figure 2. Presence of AC at input is detected and rectified to a full valid 5 V digital output ...
And here it is, modelled using LTSpice. It is the same circuit as the classic simple precision rectifier (set to pass the negative half-sine), but with the non-inverting input of the op-amp connected ...
If you are looking to replace halogen bulbs with LEDs, combining a rectifier bridge and a current-controlled synchronous step-up/step-down converter creates a high power factor driver circuit, writes ...
Some results have been hidden because they may be inaccessible to you
Show inaccessible results
Feedback